I have been working on how to construct my rudders. I have drawing which gives basic dimensions enough to form a good profile. (see attached)

From this web site http://www.history.navy.mil/photos/sh-usn/usnsh-f/dd842-c.htm I found 2 photos NH 102957 & 958 which show the rudders and propeller in dry dock from a similar ship USS Fiske DD-842.

Now I know the rudders have a air foil type cross section to them but no dimensions to go by. I can only judge the shape by the appearance in the photographs.

Any thoughts on how to model these? Is this a "best guess" situation?

thanks

Don

hello
hope this picture will help you to draw your rudder, it's from a French destroyer built in the fifties under a US blue print after WW II. Ithink it's very close to the one you are working on.
Philippe
http://shipmodeling.net/photopost/data/500/thumbs/rudder0001.jpg (http://shipmodeling.net/photopost/data/500/rudder0001.jpg)

Thanks for the link. Tonight after I got home from work I made one rudder based on the dimensions from the drawings of the ship. I thought it came out pretty good.

The stock I used was 1/8" thick basswood. I would like the hinge the two pieces together but I am afraid of spliting them.

Here's a rudder photo from a Clemson class US flush deck destroyer, the USS Farragut, DD300....

http://tommymeisel.home.insightbb.com/rearview screws.jpg

Hey.. thats pretty cool!. Almost a sharp edge on the end. The Zellars is an Allan Sumner class destroyer with twin screws and twin rudders.

I tried drilling a 1/16" diameter hole thru the 1/8" stock and found the wall to be a might thin exspecially after a little shaping. So I did some tinkering around and decided I need to go up in thickness about .03" with the stock. Drill my hole first which will allow me to put a small pin or nail to use as a hinge then do the final shaping.

I found this photo as well of the Sumner in dry dock.